[. . . ] € Identification of faults for service technician “Delayed start” button Start button The wash cycle can be programmed to start after 1 - 24 hours. With each successive touch of the button, the delayed start indicator increases by 1 hour, and after 24 returns to 00. [. . . ] Select the required detergent with the Start button (OFF = powder detergent, 2 in 1, 3 in 1, 4 in 1) (shown on the display). The selected detergent type will be shown on the display for approximately 3 seconds after switching on. For dosage of powder detergent in compartment A and B refer to the programmes table. Select, save, and supply the detergent Check the rinse aid level Check the regeneration salt level Load the racks Close the dishwasher door, turn on the water tap Select a programme The last programme selected will light up. €œChange programme in progress” Select additional options Press the Start button The selected programme is then memorised (even in the event of power failure). Wash cycle - Only open the dishwasher if necessary (Warning: beware of hot steam). - If the appliance is switched off during a wash cycle, when switched on again it will resume the cycle from where it was interrupted. Only after the START button has switched off: Press the ON / OFF button. Switch off the appliance Turn off the water tap, unload the racks Dishwasher loading instructions and racks provided depending on the model Upper rack: Crockery holder (A): Depending on the position, for long-handles utensils, cups and plates. Carving forks, knives) must be arranged with the sharp end facing in towards the appliance. b A C D Half Load: Load the upper rack (see description of Options). Rack height adjustment (also when loaded): Pull the two rack handles (D) outwards and lower the rack. [. . . ] €¢ Ensure the filter assembly is not clogged and that there is no interruption to the water supply (if necessary, clean the filters *). Press the START button for 2 seconds, until the START indicator lamp switches off. [. . . ]